NStor Technologies Disk Array Enclosure Manual do Utilizador descarregar pdf (Página 28)

Installation

Rack-Mount Subsystem Assembly

2 To aide in support bracket installation, remove the rack cabinet side panels.

3 Locate the two support brackets. Mount the two brackets to the rack cabinet

verticals using the four screws, four washers, and four caged nuts provided

for each bracket. Refer to detail “A” in the illustration on the previous page.

NOTE: The caged nuts are secured into the rack cabinet vertical slots by inserting

one side of the nut into the slot and squeezing while pressing the opposite

side in until it snaps into place.

4 Remove the two (2) upper enclosure case screws as depicted below on the

right side of the subsystem cabinet.

NOTE: The enclosure is attached to the support bracket only on the right side.

5 Slide the subsystem cabinet into the cabinet with the subsystem riding on top

of the support brackets.

6 Align the two upper case screw holes with those provided in the support

bracket on the right side.

7 Secure the subsystem cabinet to the right hand rail using the two (2) screws

previously removed.

8 Continue with the component installation on the next page.

Rail is installed to

the front and rear

rack cabinet verticals.

8-32 Pan

Head Screws

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

Sem comentários

NStor Technologies Disk Array Enclosure Manual do Utilizador Página 28